How to install self-agglutinative window picture – some tips

How to install self adhesive window film and what you need to know. How to do it correctly and what tool is needed for this? Everything is quite simple, but you demand to know the technology and follow the gild of execution.


Every bit with all films, a special tool must be used for self agglutinative window picture.

  • Sprayer for spraying liquid
  • Rubber wiper for cleaning the glass
  • Blade for mechanical glass cleaning (optional)
  • Duster for smoothing the film and squeezing the mounting mortar from under the film
  • Lint-free wipes
  • Knife with a thin blade for cut the moving-picture show forth the border

You tin get free, total window film tools from us for quality work.

Watch this Video


Attention!! Be sure to apply an assembly solution. Aye, the moving-picture show has an agglutinative layer, but the mounting solution allows you to distribute the flick evenly over the glass without air bubbles

How to install (footstep by step) cocky adhesive window film

  1. The entire instrument must be prepared.
  2. Preparing the film. It is necessary to cut the film 2-3 centimeters larger than the drinking glass. Or gild a pic of the finished size window flick cut to size.
  3. Set up the installation solution. Pour clean h2o into the sprayer. Add together mounting solution at the rate of 2-3 drops per 1 liter of h2o.
  4. Wash the glass thoroughly. Spray over with mounting mortar and gradually get through with a bract. The blade removes mechanical impurities, adhering dirt, etc.
  5. Spray drinking glass again. Wipe the frame virtually the glass with napkins. We carefully pass the glass surface with a prophylactic wiper.
  6. Spray over with mounting mortar
  7. Gradually remove the protective liner from the film and fill in the gum layer
  8. Apply the movie to the glass. The moving picture should float a little - this will allow it to be distributed without folds and air. If the flick doesn't float but is STICKED, it means a little added mounting solution.
  9. On tiptop of the picture show, spray a thin layer of assembly mortar. This will permit the window film duster (rakel) to slide over the moving-picture show.
  10. Carefully gradually nosotros go through the unabridged surface of the moving picture. With gradual light movements we bulldoze the solution out from under the film.
  11. If necessary, trim excess window film along the edge of the glass with a knife.
  12. Spray once more with assembly solution. Squeeze out the solution again, but with stronger movements.
  13. Remove moisture from the edges of the motion picture with a napkin.
  14. If necessary, afterwards 2 to 3 hours, you can gently tighten the edges of the film.

This installation principle tin be used for whatever type of window picture show. For example

  • window frosting motion-picture show
  • window mirror motion picture
  • ane way window film
  • privacy pic

There is some difference in the window glass protection motion picture, a less full-bodied assembly solution is used and the disassembly of the drinking glass structure is required (in some cases).